How can we help?

Soldermask opening for Gold fingers

Reason of failed review:

For beveling the edge connector, it would be better to expose the whole edge connector area to prevent the solder resist peeling off during use, thus causing quality problems.

Suggestion:

No matter bevel or not bevel the fingers, it's suggested to do exposure for the whole edge connector area until to border.

Last updated on 12/03/2024

If you have any question with ordering, feel free to contact us.

Was this article helpful? Yes No

If you cannot find solutions to your problem here please tell us through Facebook or Twitter.

Spacing between silkscreen and openings
Silkscreen standard size
do not design texts on the copper layer
notes in the order are different from the designs in the files
the bottom silkscreen is mirrored
limited holes spacing
silkscreen over pads
the spacing from hole to trace
The requirement of beveling on gold finger area
The spacing from one hole to another is too narrow
the spacing requirement from hole to the edge of board
Edge plating
the spacing requirement from slot to copper trace
Spiral coil board
BGA pad opening
No Gold fingers design in file
UL Marking
The are some pads out of the board outline
Design has no silkscreen layer but online is yes with silkscreen
Some Issues concerning BGA(Ball Grid Array)

Comments (0)

This message here is only a suggestion supplement to the above content, and does not for trading operations such as orders. If you have any urgent questions or order issues, please contact your sales rep.

Upload a photo: You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP

0 / 10000

How can we help?

Soldermask opening for Gold fingers

If you have any question with ordering, feel free to contact us.

How can we improve this article?

Related articles